Battery degradation is the gradual and irreversible loss of usable capacity and power in a rechargeable battery as it ages and is cycled. In EV batteries, degradation determines how much driving range a car retains over its life, how quickly it can charge and, ultimately, its resale value. It is usually expressed through the state of health (SOH), the remaining capacity as a percentage of the original.
Modern lithium-ion traction batteries typically lose a few percent of capacity in the first years, followed by a slower, roughly linear decline. Most electric vehicles in normal use retain about 80 to 90 percent of capacity after 150,000 to 200,000 kilometers, although results vary widely with chemistry, climate and usage.
How battery degradation happens inside the cell
Battery degradation results from side reactions and mechanical wear that consume lithium or damage the electrode materials. The two broad consequences are capacity fade, meaning less stored energy, and power fade, meaning higher internal resistance and lower peak output.
The dominant mechanism in most cells is the slow growth of the solid electrolyte interphase (SEI), a thin film on the graphite anode. The SEI protects the anode, but it keeps thickening over time and permanently traps cyclable lithium, a process called loss of lithium inventory. Other mechanisms damage the active materials themselves, which is called loss of active material.
The table below summarizes the main degradation mechanisms and their effects.
| Mechanism | Where it occurs | Main effect |
|---|---|---|
| SEI growth | Graphite anode surface | Loss of lithium, rising resistance |
| Lithium plating | Anode during cold or fast charging | Rapid capacity loss, safety risk |
| Particle cracking | Cathode and anode particles | Loss of active material |
| Transition metal dissolution | Nickel-rich cathodes | Cathode damage and SEI poisoning |
| Electrolyte decomposition | Electrode interfaces at high voltage | Gas generation and resistance growth |
Lithium plating deserves special attention. When lithium ions arrive at the anode faster than they can intercalate, for example during fast charging in cold conditions, metallic lithium deposits on the surface. Plating causes rapid, sometimes sudden capacity loss and can form dendrites that raise the risk of internal short circuits.
Calendar aging and cycle aging
Degradation has two components that add together: calendar aging, which occurs even when the battery rests, and cycle aging, which results from charging and discharging. In many private cars that sit parked most of the day, calendar aging is the larger contributor.
Calendar aging accelerates with high temperature and high state of charge. A battery stored at a full charge in a hot climate ages much faster than one stored at a moderate charge in mild conditions. Cycle aging depends mainly on depth of discharge, charging current and temperature during use.
The following table compares the two components.
| Aspect | Calendar aging | Cycle aging |
|---|---|---|
| Occurs when | The battery is idle or parked | The battery charges or discharges |
| Main drivers | Temperature and state of charge | Depth of discharge and charging rate |
| Typical pattern | Faster early, slowing with time | Roughly proportional to energy throughput |
| Driver influence | Parking location, charge limit | Charging habits, driving style |
Early degradation is often faster because the SEI forms most quickly at the start of life. This explains why many owners see a noticeable drop in the first year and then a much slower decline, a pattern that should not be extrapolated linearly from the first months.
How chemistry and design affect degradation
Cell chemistry sets the baseline durability of a battery. LFP batteries (lithium iron phosphate) tolerate many more full cycles than NMC batteries (nickel manganese cobalt), and they suffer less from being held at full charge, which is why manufacturers often recommend charging LFP packs to 100 percent regularly.
| Chemistry | Typical cycle life | Key sensitivity |
|---|---|---|
| LFP | About 3,000 to 6,000 full cycles | Cold-temperature charging |
| NMC | About 1,000 to 2,500 full cycles | High state of charge and heat |
| NCA | About 1,000 to 2,000 full cycles | High voltage and heat |
| Sodium-ion | Still being established in vehicles | Lower energy density limits use |
Cycle life figures depend strongly on the test conditions and end-of-life threshold, usually 70 or 80 percent of original capacity, so they are useful for comparing chemistries rather than for predicting one specific car. System design matters as much as chemistry. A liquid thermal management system keeps cells in their preferred range, and a buffer of reserved capacity hidden by the BMS means that the usable battery capacity shown to the driver never reaches the true electrochemical limits.
Measuring and managing battery degradation
Degradation is measured by estimating the state of health, which the battery management system (BMS) calculates from capacity and internal resistance. Because the BMS estimates rather than directly measures capacity, the displayed SOH can drift, and a controlled full discharge test gives the most reliable figure.
Drivers can slow degradation considerably with a few habits. The decision table below summarizes the most effective ones.
| Situation | Recommended practice | Reason |
|---|---|---|
| Daily commuting | Limit NMC charge to about 80 percent | Reduces calendar aging at high voltage |
| Long parking periods | Store at roughly 40 to 60 percent | Minimizes side reactions |
| Hot climate | Park in shade, keep thermal management active | Heat accelerates SEI growth |
| Cold climate fast charging | Precondition the battery before charging | Prevents lithium plating |
| Road trips | Charge to 100 percent shortly before departure | Limits time spent at full charge |
Occasional DC fast charging has a modest effect on well-managed packs, because the BMS limits current when cells are cold or nearly full. Frequent fast charging combined with heat, however, measurably increases degradation, especially in vehicles without active liquid cooling.
Common misconceptions about battery degradation
Many concerns about EV batteries come from experience with phone and laptop batteries, which age faster because they lack thermal management, are often kept at full charge and use small, highly stressed cells. Traction batteries are designed with larger margins and active cooling.
- Degradation is not linear: an early drop does not mean the battery will continue to lose capacity at the same rate.
- Range loss is not the same as capacity loss: winter temperatures temporarily reduce range without permanent damage.
- End of vehicle life is not end of battery life: a pack at 70 percent capacity can still serve in stationary energy storage.
- Software updates can change displayed range: a revised BMS estimate is not necessarily real degradation.
Most manufacturers offer a battery warranty of about eight years with a guaranteed minimum capacity, commonly 70 percent, which reflects their confidence that typical degradation stays well above that level.
Explained without jargon
Every rechargeable battery slowly wears out, just as shoe soles get thinner with each walk. In an electric car, this means that the battery holds a little less energy each year, so the car can drive slightly fewer kilometers on a full charge.
Heat, long periods at full charge and charging very fast in the cold speed up this wear. Keeping the battery away from these extremes helps it last much longer. Most modern EV batteries keep most of their capacity for well over a decade, so the car usually wears out in other ways first.
A typical use case
A fleet manager at a delivery company runs 40 electric vans with 75 kWh NMC packs, each driving about 120 kilometers per day. After two years, the telematics data shows that vans charged overnight to 100 percent and parked in a sunny yard have a state of health near 89 percent, while the vans parked in a covered garage are near 93 percent.
The manager sets the daily charge limit to 85 percent, which still covers each route with a reserve, and moves more vans under cover during summer. Over the next two years, the average degradation rate drops by roughly a third. The fleet can therefore delay battery replacement, keep the vans in service longer and achieve a higher residual value when they are sold.