Well-to-wheel emissions

On this page 7

Well-to-wheel emissions are the total greenhouse gas emissions released per unit of distance across the full energy chain of a vehicle, from extracting and converting the primary energy source to consuming the final energy carrier on the road. In the study of electric vehicles, the metric is the standard way to compare a battery electric car charged from the grid with a gasoline, diesel, hybrid or hydrogen vehicle on equal terms, because a tailpipe measurement alone hides the emissions of power plants and refineries.

The result is usually expressed in grams of CO2-equivalent per kilometer (gCO2e/km) or per mile. It covers fuel and electricity, but it deliberately excludes vehicle and battery manufacturing, which belong to the wider life cycle assessment.

How the well-to-wheel chain is divided

A well-to-wheel analysis splits the energy chain into two stages that are calculated separately and then added together. The split makes it possible to see whether the emissions of a vehicle come mainly from its energy supply or from the vehicle itself during driving.

  • Well-to-tank (WTT) covers extraction, processing, transport and distribution of the energy carrier up to the fuel tank or charging connector. For electricity, it includes generation and grid losses.
  • Tank-to-wheel (TTW) covers the conversion of stored energy into motion inside the vehicle. For combustion engines, this stage includes tailpipe CO2; for a battery electric vehicle, it is zero direct emissions.
  • Well-to-wheel (WTW) is the sum of both stages, which is the figure used in policy and fleet comparisons.

The following table shows where emissions arise in each stage for the main propulsion types discussed in EV fundamentals.

Vehicle typeWell-to-tank sourcesTank-to-wheel sources
Gasoline carOil extraction, refining, transportCombustion CO2 at the tailpipe
HEV or MHEVSame as gasolineLower combustion CO2 through recovery
PHEVRefining plus electricity generationCombustion only in fuel mode
BEVElectricity generation, grid and charging lossesNone
FCEVHydrogen production, compression, deliveryNone, only water vapor
Where emissions occur in each stage

Factors that drive the well-to-wheel result

The well-to-wheel figure of an electric car depends above all on the carbon intensity of the electricity used for charging. Grid intensity varies from below 50 gCO2/kWh in hydro- or nuclear-dominated systems to more than 700 gCO2/kWh in coal-heavy systems, so the same vehicle can produce very different results in different countries.

Vehicle efficiency and charging losses multiply that intensity. A compact BEV typically consumes 14 to 18 kWh per 100 km at the wheels, and AC charging adds roughly 10 to 15% losses between the grid and the battery. The table summarizes the main parameters and their effect.

ParameterTypical rangeEffect on WTW result
Grid carbon intensity20 to 800 gCO2/kWhDominant factor for BEVs
Vehicle consumption13 to 25 kWh/100 kmScales emissions linearly
Charging losses5 to 15%Adds to energy drawn from the grid
Fuel upstream share15 to 25% of gasoline WTWOften omitted in tailpipe figures
Hydrogen pathwayGray, blue or greenDecides whether FCEVs gain anything
Key parameters and their effect

For combustion vehicles, the upstream share is smaller but not negligible. Extraction, flaring, refining and transport add roughly a fifth to a quarter on top of the tailpipe emissions, which is why a car rated at 120 gCO2/km at the tailpipe may reach about 150 gCO2e/km well-to-wheel.

Well-to-wheel emissions sit between the narrow tailpipe figure and the full cradle-to-grave life cycle assessment. Confusing these scopes is the most frequent source of misleading claims about electrified vehicles, so the boundary of any quoted number must be stated.

MetricWhat it includesTypical use
Tank-to-wheelDirect vehicle emissions onlyType approval and fleet CO2 limits
Well-to-wheelEnergy supply plus vehicle operationFuel and powertrain comparisons
Life cycle assessmentWTW plus manufacturing and end of lifeFull climate footprint of a model
Zero-emission vehicle labelAbsence of tailpipe emissionsRegulatory classification
Comparison of emission accounting scopes

A zero-emission vehicle is therefore zero only in the tank-to-wheel sense. Its well-to-wheel result is positive whenever the electricity or hydrogen is produced with fossil fuels, and its life cycle footprint also includes the carbon cost of the battery, which a well-to-wheel figure does not capture.

Calculation methods and accounting choices

The basic calculation for a battery electric vehicle multiplies energy drawn from the grid per kilometer by the grid emission factor. A car using 17 kWh/100 km at the battery, with 10% charging losses, draws about 0.19 kWh/km; at 300 gCO2/kWh, the result is roughly 57 gCO2e/km.

Several methodological choices change the answer significantly, and transparent studies state them explicitly. The most consequential are listed below.

  • Average versus marginal emissions: the average grid mix spreads emissions across all demand, while the marginal approach assigns the generator that responds to extra load, often a gas plant.
  • Annual versus hourly data: charging at night or during solar peaks can differ substantially from the annual average.
  • Test cycle versus real-world consumption: laboratory cycles such as WLTP tend to understate real consumption, especially in winter and on highways.
  • Future grid trajectory: a vehicle used for 15 years will charge from a grid that usually decarbonizes over time, while a fuel’s upstream footprint changes little.

In Europe, the JEC well-to-wheels study by the European Commission research service, EUCAR and Concawe is a widely cited reference framework, and the GREET model fills a similar role in the United States.

Limitations and common misconceptions

Well-to-wheel emissions are a powerful comparison tool, but they answer a limited question. They describe the climate impact of energy use, not the whole environmental profile of a vehicle.

MisconceptionWhy it is wrongCorrect view
EVs are dirty on coal gridsHigher drivetrain efficiency offsets part of itResults vary; often near parity at worst
WTW shows the full footprintManufacturing is excludedUse LCA for the full picture
Hydrogen is always cleanMost hydrogen comes from natural gasDepends on the production pathway
One number fits every countryGrid mixes differ widelyUse local and time-specific data
Common misconceptions and corrections

Further limits include non-CO2 effects such as particulate emissions from tires and brakes, which occur in all vehicle types, and the treatment of renewable electricity contracts, which can make a charging operator appear cleaner than the physical grid supplying its stations.

In everyday language

Well-to-wheel emissions answer a simple question: how much climate pollution does it take to move a car one kilometer, counting everything from where the energy comes from to the moment the wheels turn. A tailpipe tells only half the story. Gasoline has to be pumped and refined first, and electricity has to be generated somewhere.

Think of it like counting the cost of a meal. You count not only cooking at home but also farming and shipping the ingredients. Electric cars look best where electricity is clean, and they still tend to come out ahead on most grids because their motors waste far less energy than engines.

Seen in the real world

A municipal fleet manager is choosing between 40 compact gasoline cars and 40 battery electric cars for city inspectors who each drive about 15,000 km per year. The gasoline model is rated at 125 gCO2/km at the tailpipe, which becomes roughly 155 gCO2e/km well-to-wheel once refining and fuel transport are added.

The electric model draws about 0.18 kWh/km from the grid including charging losses. With a regional grid intensity of 250 gCO2/kWh, it reaches about 45 gCO2e/km. Across the fleet, annual operating emissions fall from about 93 tonnes to about 27 tonnes, a reduction of roughly 70%.

The manager also checks a coal-heavy scenario at 700 gCO2/kWh, where the electric car reaches about 126 gCO2e/km. Even in that worst case it stays slightly ahead, and the report notes that battery manufacturing must be assessed separately in a life cycle study.